![]() If you need a locksmith in Connecticut or Westchester County, New York, call All American Locksmiths today. We can help you figure out the cause of the problem and repair or replace the door or frame if necessary. Call American Locksmiths to Have Your Lock or Door Problem FixedĪt All American Locksmiths, we have encountered many problems with locks not working that were actually caused by other issues related to doors, door jambs, and frames. I did more research and based on problems other people are having, it seems like its either the voltage coming from the ecu is too low, or the motors in the. If the door is sagging, it can be repaired by removing one of the screws near the center of the door jamb, replacing it with a longer one that extends through the door jamb into the frame, and then tightening the screw until the hinge pulls back slightly. Carpet or flooring could also be making it difficult to open or close the door. This can cause the door to sag from the top. If the entry door is rubbing on the bottom edge of the frame, it could be because the door is too heavy and the hinges or frame have become damaged. If a larger adjustment is necessary, the strike plate can be removed and repositioned. Then the metal can be filed to make the opening large enough for the latch to engage. This can be corrected by removing the strike plate. If the door will not stay latched or needs to be pushed hard to make it latch, the latch bolt may be sticking in the strike plate. It may be necessary to adjust the size of the door or to tighten and clean the hinges. It could also be difficult to open and close a door because of loose hinges. This can affect the alignment and cause a door to stick. Rain, wind, and changes in temperature can affect entry doors, causing them to expand and contract. This can be fixed by tightening any loose screws or sanding the door. If it is hard to open a lock with a key after it rains, the weather could have caused the door to warp or swell. It may be necessary to make simple adjustments to properly align the door, strike plate, and bolt. The door may also be warped or not hanging squarely in the frame. If a deadbolt lock sticks and is hard to operate, it could be because of poor workmanship or because of the house settling. It may be necessary to remove the strike plate and file the metal to enlarge the opening so the latch can engage or to move the strike plate higher or lower on the door frame. The wood frame may also be drying out, which can cause the door latch to hit the strike plate instead of entering the hole in the plate. In new homes, settling in the foundation can cause locks to not work properly. Entry Door Lock Problems Caused by Doors & Door Frames Door Does Not Lock ![]() These are some of the most common issues which door repair or door jamb repair services from an experienced locksmith might be needed. In these situations, door repair or door frame repair might be needed. In many cases, however, the problem actually lies with the door or door frame. People often find that their locks or doors are not working properly and assume that the lock needs to be repaired or replaced.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |